How long do PVC, laminate and parquet floors last in the Netherlands? When renewing a floor in the...

MULTI Klussenbedrijf6 Nov
Translated by AtaList·

How long do PVC, laminate and parquet floors last in the Netherlands?

When renewing a floor in the Netherlands, you should look not only at the price per square metre but also at how many years the chosen material will last.

In average use, laminate can last 10–20 years, PVC flooring 15–25 years, and multi-layer wood parquet (lamellenparket) 20–40 years. Solid wood parquet, however, can be used for more than 50 years with proper maintenance and sanding when needed.

However, these periods are not exact. The same floor material can last many years in a rarely used apartment, while it may wear out faster in a home with children and pets.

1. Which floor material lasts longer?

The approximate service lives of the floor types commonly used in Dutch homes are as follows:

Floor typeAverage service life

Laminate

10–20 years

PVC click or tile

15–25 years

Lamellenparket (engineered parquet)

20–40 years

Massief parket (solid parquet)

50 years and more

Ceramic tile

30–50 years and more

The most important difference here is whether the material can be repaired.

When the decorative surface of laminate or the protective layer of PVC wears away, these materials cannot be sanded like classic wood parquet.

Real wood parquet, on the other hand, can be sanded again and oiled or varnished as long as it has sufficient thickness. This also significantly extends its total service life.

2. Why does laminate flooring wear out early?

Laminate is preferred in the Netherlands especially for economical floor renovations. It is relatively easy to install and offers different wood appearances.

However, the durability of every laminate is not the same.

Especially in heavily used areas such as the living room, hallway and kitchen, products with AC4 or higher abrasion class may be preferred.

One of laminate's biggest problems is moisture. Water remaining on the floor surface for a long time can seep in through the joints of the boards and cause the HDF core to swell.

As a result:

  1. Board edges can lift.
  2. Joints can open.
  3. Permanent damage can form on the surface.
  4. Click connections can be damaged.

In some cases, only the damaged boards can be replaced. However, if swelling has occurred over a large area, it may make more sense to renew the entire floor.

3. Why is PVC flooring more durable?

PVC has become quite widespread in the Netherlands in recent years, both in new homes and in renovation projects.

It is especially preferred for its moisture resistance, ease of cleaning and options compatible with vloerverwarming (underfloor heating).

A good-quality PVC floor can be used for approximately 15–25 years.

However, it is not correct to look only at the thickness of the product. One of the most important features is the thickness of the protective wear layer on top.

For example:

  1. 0.3 mm slijtlaag (wear layer): May be suitable for less used areas such as bedrooms.
  2. 0.55 mm slijtlaag (wear layer): More advantageous in heavily used areas such as living rooms and hallways.

PVC has two common installation methods.

Click-PVC: The pieces interlock and are laid on a suitable underlay.

Plak-PVC (glue-down PVC): The planks are glued directly to the floor. It can offer a thinner structure but requires a very even subfloor.

Especially for plak-PVC, floor levelling and egaliseren (self-levelling compound) work should not be neglected. Small irregularities in the floor can become noticeable on the PVC surface over time.

4. Why do real wood parquet floors last longer?

Wood parquet may require more maintenance than laminate and PVC. In return, its most important advantage is that it can be repaired.

For example, lamellenparket is a multi-layer product with a real wood top layer. Depending on the thickness of the upper wood layer, it can usually be sanded one to three times.

Massief parket (solid parquet), being made of thicker natural wood, can be renewed more times under suitable conditions.

Each sanding process can remove approximately 0.5–1 mm from the wood surface. Therefore, how many times a floor can be renewed depends on the thickness of the existing wood.

There are two common surface treatments for wood parquet:

Geolied parket (oiled parquet): Wood parquet protected with oil. It may require regular oil maintenance.

Gelakt parket (lacquered parquet): Parquet protected with varnish. When the protective layer on the surface wears away, a suitable renewal process can be carried out.

One of the most important conditions for using wood parquet for a long time is having maintenance done without waiting for the surface to wear away completely.

5. How do winter months affect the floor in the Netherlands?

The Dutch climate has a significant effect especially on laminate and wood parquet floors.

Sand and water carried into the house with the rain in autumn can accelerate floor wear.

In winter, the air inside dries out as the radiators run. This can cause wood parquet to lose moisture and shrink, forming small gaps between the boards.

For wood floors, a relative humidity of approximately 45–60% is generally considered suitable.

If the humidity level stays low for a long time, gaps of around 1–2 mm may appear between parquet joints.

It is useful to monitor the humidity in the room with a simple hygrometer (humidity meter).

In homes with vloerverwarming, attention should be paid to the maximum surface temperature of the floor. For many PVC and parquet products, this limit is approximately 27 °C; the value to follow is the manufacturer's technical instructions.

6. What should be done to extend the life of the floor?

Proper maintenance is just as important as buying an expensive floor.

One of the most effective measures is placing a good schoonloopmat (dirt-trapping doormat) at the entrance. An effective mat area of approximately 1.5–2 metres can reduce the amount of sand and dirt carried in on shoes.

In addition:

  1. Protective felt pads should be fitted to chair and table legs.
  2. Floor protectors should be used for office chairs with hard wheels.
  3. Excess water should not be left on the floor during cleaning.
  4. pH-neutral cleaners suitable for PVC should be preferred.
  5. Oiled wood parquet should be maintained on time.
  6. Spills should be cleaned up as quickly as possible.

After floor installation, it is also useful to keep a few packs or boards as spare material. The same product may not be available in the same colour and production series a few years later.

7. Why is the subfloor so important?

The reason for early floor wear is not always the material on top.

For example, in an old Dutch apartment, if the wooden load-bearing floor moves, laminate or click-PVC laid on top may eventually creak.

Similarly, an improperly installed dekvloer (screed/subfloor) can create stress at board joints.

For this reason, the correct order for floor renewal is usually as follows:

  1. Removal of the existing floor covering.
  2. Checking the subfloor for soundness and moisture.
  3. Repairing cracks and damage if necessary.
  4. Application of suitable egaliseren or ondervloer (underlayment).
  5. Installation of the new PVC, laminate or parquet.
  6. Completion of skirting boards (plinten) and transition profiles.

Especially in apartments, the sound insulation requirements of the VvE (owners' association) should also be taken into account.

MULTI Klussenbedrijf evaluates the condition of the existing subfloor together with the technical requirements of the chosen material for floor installation and renovation work.

8. Should the old floor be repaired or completely replaced?

Sometimes it can be more economical to repair only the damaged sections instead of replacing the entire floor.

For the Randstad region in 2026, approximate prices are as follows:

WorkApproximate price

Sanding and renewing wood parquet

€25–€45/m²

Replacing a few PVC or laminate boards

€150–€400

Removing and re-laying laminate

€30–€60/m²

Renewing PVC flooring

€45–€85/m²

These figures are indicative. They can vary depending on the scope of the work, the condition of the existing floor and the product choice.

If the top layer of wood parquet is thick enough, sanding is often more economical than a complete replacement.

For laminate, swelling spread over large areas, or for PVC, deep scratches that go through the protective layer, replacement may be necessary.

For a new PVC floor, you can compare material, labour and preparation costs in the 2026 PVC floor installation costs guide.

Conclusion: Which floor makes more sense in the Netherlands?

When choosing, it is necessary to look at the total service life rather than only the initial price.

Laminate is an economical and easy-to-install option. PVC offers a durable and practical-to-maintain solution in heavily used living rooms and hallways. Real wood parquet, thanks to regular maintenance and renewal options, can be used for decades.

In Dutch homes, moisture, subfloor structure, underfloor heating and VvE conditions in particular matter in material selection.

When the right material, proper subfloor preparation and regular maintenance come together, the service life of a floor covering can be significantly extended.

🌐 MULTI Klussenbedrijf

📧 E-mail: info@multiklussenbedrijf.nl

💬 WhatsApp: Click to send a message

📝 Quote: Click to get a quote right away

How long do PVC, laminate and parquet floors last in the Netherlands? When...
000442

No comments yet. Be the first to comment!